Walker Industrial: Home > Manufacturers > A - D > ABB > ABB Low Voltage Controls > Enclosures > C2 Console - IP 55

C2 Console - IP 55
IS2 Cabinets
Aesthetically it has been harmonized with the IS2 and AM2 automation cabinets, taking on not only their appearance but also several of the existing Accessories.

The new C2 console range is inserted to complete the offer of automation switchboards and is available in the monobloc version (codes CM…K) Aesthetically it has been harmonized with the IS2 and AM2 automation cabinets, taking on not only their appearance but also several of the existing Accessories.

The C2 consoles are built of steel sheet 15/10 mm thick The range, characterised by the IP55 degree of protection, has passed the controls needed to obtain the UL (Underwriters Laboratories) and CSA (Canadian Standards Association) Type 12 marks. The standard colour is orange peel RAL7035. On request, it is possible to order the console in a wide range of RAL colours (see page 8/13). The plinth is RAL 7012 colour.

Technical characteristics

Conformity with the IEC 62208 Standard
IP55 degree of protection (IEC 60529) TYPE 12 (UL Regulations) IK10 degree of mechanical impact (IEC 62262)

The range, characterized by the IP55 degree of protection, has passed the controls needed to obtain the UL (Underwriters Laboratories) and CSA (Canadian Standards Association) Type 12 marks.

Versions available
  • The C2 consoles are divided into two versions:
  • Monobloc H=1000mm version
  • Monobloc version with H=1400mm raised back with panel or rear door
The H=1000mm version is managed on a single depth of the base D=400mm and in 5 widths which are W=600-800-1000mm with single door and 1200-1600mm with double door. They are used, in particular, as monobloc control pulpits for small on-board machine systems.

The H=1400mm version is managed with two depths of the base which are D=400-500mm and in 5 widths which are W=600-800- 1000mm with single door and 1200-1600mm with double door. Both versions are fitted with 4 angle pieces correctly sized to facilitate handling and must then be completed with the plinth flanges.

Many of the completion Accessories are in common with the existing IS2 and AM2 automation ranges so as to simplify and optimize code management.

pdfDownload the Enclosures for Automation brochure in *.pdf format