Home > Manufacturers > K - O > KB Electronics > DC Drives > Chassis IP-20 DC Drives > KBTC Torque Controls >

KBTC-225 KB Electronics 230 VAC, 0-10 Amps ARM (9101)

KBTC-225 KB Electronics 230 VAC, 0-10 Amps ARM (9101)
KBTC-225
 
Price: $121.10
Manufacturer SKU: KBTC-225
Manufacturer ID: 9101

Quantity in Stock:1

Free Shipping
Availability: Normally Stocked
Part Number: KBTC-225
Qty:

Description
 
KBTC-225 KB Electronics 230 VAC, 0-10 Amps ARM (9101)

Plug-in Horsepower Resistor Required The control must have a Plug-in Horsepower Resistor installed; purchased separately
Plug-in Line Fuse Optional Optional fuse mounting kit can be added; Plug-in Line Fuses purchased separately
Plug-in Armature Fuse Optional Optional fuse mounting kit can be added. Plug-in Armature Fuses purchased separately


pdf Consult the Plug-in Horsepower Resistor and Plug-in Fuse Selection Charts for proper sizing based on motor horsepower and amperage.
KBTC225
Additional Product Information

The KB Electronics KBTC-225 is designed to control a motor's torque, by controlling motor current. Unlike a traditional DC motor speed control, which controls voltage and limits current, the main potentiometer of the KBTC sets the current. The motor current will not vary over the speed range if the load is less than the current set point; the KBTC goes to maximum voltage.

The KBTC-225 model operates from a 230 VAC, and powers up to a 2 HP, 180 volt motor

The KBTC connections are the same as a KBIC DC motor speed control. Accessories include Barrier Terminal Board, Barrier Terminal Kit and SI-5 signal isolator. The KBTC-125 uses one Plug-in Horsepower Resistor (0.015 ohm) for all motor sizes.

The only trimpot on the control is the MAX current trimpot. It sets a percentage of the maximum allowable current so it can accommodate smaller motors. The inhibit and auto inhibit circuits work just as on the KBIC, and each control includes a fixed acceleration capacitor to control the rate of rise of current in the motor when first turned on.

Dimensions: 4.30" x 3.60" x 1.30".