Home > Manufacturers > K - O > KB Electronics > DC Drives > Chassis IP-20 DC Drives > KBWD Pulse Width Modulated Whisper Drive >

KBWD-13 KB Electronics 115 VAC, 3.0 Amps, 130 VDC ARM (8609)

KBWD-13 KB Electronics 115 VAC, 3.0 Amps, 130 VDC ARM (8609)
KBWD-13
 
Price: $94.55
Manufacturer SKU: KBWD-13
Manufacturer ID: 8609

Quantity in Stock:1

Availability: Normally Stocked
Part Number: KBWD-13
Qty:

Description
 
KBWD-13 KB Electronics 115 VAC, 3.0 Amps, 130 VDC ARM (8609)

Plug-in Horsepower Resistor Required The control must have a Plug-in Horsepower Resistor installed; purchased separately
Plug-in Line Fuse External No provisions for mounting fuse on the control; Customer needs to provide external means of fusing the control. Plug-in Line Fuses purchased separately
Plug-in Armature Fuse External No provisions for mounting fuse on the control; Customer needs to provide external means of fusing the control. Plug-in Armature Fuses purchased separately


pdf Consult the Plug-in Horsepower Resistor and Plug-in Fuse Selection Charts for proper sizing based on motor horsepower and amperage.
KBWD13
Additional Product Information

The KB Electronics KBWD Pulse Width Modulated (PWM) DC motor speed control provides excellent dynamic response to load variations. The efficient PWM waveform produces an almost pure DC current to the motor (form factor < 1.05) which has several advantages over a conventional SCR control. The PWM significantly lowers audible motor noise and provides longer brush life. It also produces less motor heating which allows a smaller, less costly motor to be used for most applications. Another advantage of PWM is higher output voltage which provides increased output speed. In addition, pulse-by-pulse current sensing provides short circuit protection and prevents control damage due to shorted motors.

A unique feature of the KBWD control is the Plug-in Horsepower Resistor. It eliminates the need for recalibrating IR Comp and Current Limit when the control is used on various horsepower motors.

The control contains armature feedback which provides excellent load regulation. The control contains quick disconnect terminals as standard. A potentiometer (5K), isolated analog signal (0-5 VDC), or PWM microprocessor output can be used to vary the output of the control.