Walker Industrial: Home > Manufacturers > Dalton Gear Company > Overload Safety Devices > Sprockets For Use In OSD Units

Dalton Sprockets For Use In OSD Units
Sort By:
1
   
 
1
Specialy ground sprockets are recommended for use with all Torque Limiters. Both faces of Dalton OSD sprockets are ground to approximately a 32 micro-inch finish. Uniform surfaces and parallel faces insure that Dalton OSD's will maintain proper torque release and re-engagement much longer than units without special sprockets. In addition, fibers last longer and OSD's require less maintenance.


MINIMUM SIZE SPROCKETS TO FIT OSD UNIT
OSD-131OSD-225OSD-256OSD-337OSD-362OSD-450 OSD-493OSD-600OSD-750OSD-900
25A20G25A32G35A25G35A31G35A34G35A41G*41A35G*41A52G*40A52G* 60A41G*
35A14G35A22G41A20G41A25G41A26G41A32G40A35G*40A42G*50A42G*80A32G
41A12G41A18G40A20G40A25G40A26G40A32G50A28G*50A34G60A35G*100A26G
40A12G40A18G50A17G50A21G50A22G50A26G60A24G60A30G80A27G120A22G
50A10G50A15G60A15G60A18G60A19G60A23G80A19G80A22G100A22G140A20G
60A13G 80A14G80A15G80A18G100A16G100A19G120A19G160A18G
100A15G120A14G120A17G140A17G
120A13G 140A15G160A15G
160A14G
Other size sprockets can be furnished
*3 fibers must be used