• Adjustable zero and span
• Various sensing ranges
• Narrow sensing beam
• LED strength indicator
• Short circuit protected
• Reverse polarity protected
• Analog current and voltage outputs
• Selected inverted and non-inverted outputs
• Self-contained barrel housing
• Input voltage 20-30 VDC
• Stainless housing

The RPS-401A, RPS-426A analog ultrasonic sensor is mounted in a 30mm barrel housing, and is completely self contained. It is powered by 20-30VDC, and is reverse polarity protected. It also has a narrow beam angle which enables it to get into tight places. A flat target can tilt up to 8 degrees and still be detected. The RPS-401A, RPS-426A have 2 short circuit protected analog outputs, 4-20mA and 0-10 VDC. These outputs can easily be inverted and can be scaled over almost any range by means of adjusting the zero and span controls. For set-up purposes an LED strength indicator is provided. This LED is Green when not detecting and fades to Red as a target moves into place, depending on how much reflected signal is coming back from the target. These analog ultrasonic sensors can be used as a level sensor, loop control, roll diameter, and many more applications where a continuous distance measurement is required.

The RPS-426A has a 8" to 80" range and operates at a frequency of 150kHz. The RPS-426A is stainless steel. The barrel measures 30mm x 100mm. A standard 6' cable is provided. An optional quick disconnect plug is available.

Download the RPS-426-80QD datasheet in *.pdf format