TCR Series
The TCR Series of solid-state temperature control is a low cost modular approach to accurate control of temperature. The high power output is available in 6, 10 and 20 amperes and provides setpoint temperature control. The efficient mounting surface allows for utilization of equipment as the heat sink. Designed for use with resistive loads.
Operation:
Setpoint Control: TCR Series is a single setpoint temperature controller. When the thermistor resistance is high (above the setpoint), the solid-state output is ON. When the thermistor resistance decreases (temperature increases) to setpoint or below, the output turns OFF.
It must be recognized that temperature differential (under and overshoot) is largely due to the system as a whole. The mass of the system, size of the heaters and sensor all play an important part. Single setpoint control is best when there is little or no lag time between heater and sensor, and when the heater is not oversized.
Features:
- NTC thermistor sensing for low cost setpoint
control
- Solid-state output to control resistive heaters
- 6, 10 or 10A solid-state output
- External adjustment of the setpoint
- Small package, encapsulated, single-screw
mounting
- Metal back surface, utilizes equipment as heat
sink
Auxiliary Products:
- Female quick connect:
- P/N: P1015-13 (AWG 10/12)
- P/N: P1015-64 (AWG 14/16)
- P/N: P1015-14 (AWG 18/22)
|
|
