FS1A Controller
When you want a straightforward system thatâ™s safe, easy-to-use and wonâ™t cost an arm and a leg, a SafetyOne FS1A safety controller is the answer!
Unlike a multiple safety relay system, which requires cumbersome wiring and take up too much space, or safety PLCs that can be costly and difficult to program, our safety controllers make it easy to consolidate safety circuits. At the same time they meet safety requirements, save space with minimal wiring and cost customers less money.
SafetyOne can replace up to six safety relay modules with no programming. Easily configure by turning on a dip switch to 1 of 8 or 24 pre-difined logic circuits and one module can connect with various IDEC safety and non safety components such as Emergency Stop switches, Interlock Switches, pilot lights, sensors and light curtains. With up to 6 dual channel safety inputs, 4 safety outputs and multiple non safety inputs, monitor, blanking and solenoid drive outputs, SafetyOne can simplify your complete safety and logic circuit.
FS1A is UL listed, TUV rated and CE marked, as well as meets IEC 61508 integrity level 3, ISO 13849-1 performance level e and EN954-1 safety category 4.
Key Features
- No programming required
- Set up to 6 dual channel inputs & quad, dual or single channel outputs
- Select safety circuit logic from 8 or 24 pre programmed circuits
- One module can connect with various types of safety inputs such as E-stop switches or light curtains
- Easily monitor logic circuit, I/Os and error codes with I/O LEDs and two 7 Segment LED display
- IEC 61508 integrity level 3, ISO 13849-1 performance level e and EN954-1 safety category 4 compliant
|
|
|
